Codelocks CL100 Surface Deadbolt User Manual download pdf (Page 1)

Surface Deadbolts

& Key Override Versions

Helpline, service & spares

FREEPHONE 0800 393 405

CODELOCKS LTD

Tel 01635 239645

Fax 01635 239644

[email protected]

www.codelocks.com

Remove the inside cover plate from the back plate, and

install the deadbolt according to the hand of your door.

Note that the standard bolt projects 40mm to the locking

side. A shorter bolt which projects 20mm is available.

Set the back plate with the knob in the vertical position and

hold it to the door with one end of the bolt against the frame

where the keeper will be fitted (see step 5).

Mark the position of the top fixing hole, and then using one

of the packing pieces as a template mark the position of the

lower fixing hole and the hole for the spindle.

Drill 8mm holes for fixing bolts and 13mm hole for spindle.

First select the appropriate keeper for your frame.

Position the keeper on the frame so that it lines up with the

deadbolt and mark the appropriate holes.

If you are using the Surface Keeper simply screw into place

(see fig. 5.1). Use the packing pieces as required.

The Mortice Keeper will require cutting a small recess

(see fig. 5.2).

Surface Keeper

fig. 5.1

Mortice Keeper

fig. 5.2

Note:

Establish which

keeper to use,

and mark its

position on the

frame, before

proceeding to

drill the door

for the lock

(see step 5).

Note:

Do not close the

door until you

are SURE that

the code works.

The spring loaded spindle will fit doors between 35mm and

65mm thick. For doors less than 50mm thick break off the

15mm section at the end of the spindle. For doors more

than 65mm thick ring the helpline for advice. The spring

keeps the spindle firmly engaged in the outside handle when

the lock is assembled on the door.

Cut the fixing bolts to suit the door thickness, allowing for

the rubber seals and at least one threaded section to screw

into the lock case.

Note that the bottom fixing bolt will be longer than the top.

Hold the lock case and the back plate, with the neoprene

seals in place, onto the door with the spindle in position.

Using the top fixing bolt first screw everything together.

INSTALLATION INSTRUCTIONS

II-1/200SD-V02

3. POSITIONING THE LOCK 4. FIXING THE LOCK 5. FITTING THE KEEPER

1 2

Summary of Contents

Page 1 - INSTALLATION INSTRUCTIONS

Surface Deadbolts & Key Override VersionsHelpline, service & spares FREEPHONE 0800 393 405CODELOCKS LTD Tel 01635 239645 Fax 01635 239644 sale

Page 2 - To enable LOCKING of the

Use surface keeperfor inswingingdoorsUse morticekeeper for outswinging doorsRIGHT HAND LEFT HANDYour door is right-handed if, viewed from outside, the

Comments to this Manuals

No comments

Codelocks CL100 Surface Deadbolt User Manual Page 1

Browse online or download User Manual for Safety Codelocks CL100 Surface Deadbolt. Codelocks CL100 Surface Deadbolt User Manual [en]

Summary of Contents

Comments to this Manuals

Codelocks CL100 Surface Deadbolt User Manual Page 1

Browse online or download User Manual for Safety Codelocks CL100 Surface Deadbolt. Codelocks CL100 Surface Deadbolt User Manual [en]

Summary of Contents

Comments to this Manuals

Related products and manuals for Safety Codelocks CL100 Surface Deadbolt